WOOL LUBE
(Rubbing Lubricant)

Product Label Text
B730-1365

H. Behlen Wool-Lube
is a specially formulated concentrated liquid rubbing lubricant.
Wool-Lube is non-toxic and non-flammable.

DIRECTIONS:
SHAKE WELL BEFORE USING.
Wool-Lube may be mixed 1-1 with water.

LEVELING BURN-IN REPAIRS:
Once a burn-in has been leveled and allowed
to cool or harden, apply a small amount of
Wool-Lube to 800 waterproof sandpaper wrapped around a cork sanding block.

Begin leveling with the grain using light even strokes (be careful not to cut through surrounding color.)

After a few strokes, stop and examine repair.
Continue sanding until repair is level with surrounding surface.

Wipe off excess Wool-Lube with a water dampened cloth.

Adjust sheen of repair with new topcoat.

• • • • •

KEEP OUT of REACH of CHILDREN
Avoid Contact with Eyes

RUBBING FINISHES:
Follow coating manufacturer’s dry time when rubbing new finishes.

Place a small amount of H. Behlen Wool-Lube on steel wool, an abrasive pad or waterproof sandpaper.

Rub in the direction of the grain with smooth even strokes.

Reapply Wool-Lube as needed until desired rubbing effect is achieved.

Wipe off excess Wool-Lube with a water dampened cloth.

Wool-Lube will not cause adhesion problems
if recoating.

Apply wax or polish as desired to protect the finish.

---

Additional Notes:
A more agresive cutting action will result when Wool-Lube is mixed with water.

For Best Results when rubbing out a finish, make sure the finish is fully cured and not just dry.
Most air dry finishes need a full 21-30 days under good conditions to achieve maximun cure and hardness. The harder the finish the more predictable and consistant the result.

Shellac.net Wood Finish Supply

Back To: Finish Rubbing, Polishing, Deluxing & Finish Care
To: BEHLEN Index Page . rev.1/17/14 . Home: Shellac.net